QEP 650XT Owner's Manual download pdf (Page 9)

– 7 –

FIGURE 8

INSTALLING THE ANGLE GUIDE

(see FIGURE 9)

1. The angle guide is designed to t on top of

the rip guide. Simply place angle guide onto

the top of the rip guide.

NOTE: The angle guide can be placed on either

the left or right side.

FIGURE 9

OPERATION

IMPORTANT: ALWAYS turn off the saw and

remove the plug from the outlet BEFORE

adding or removing accessories and making

adjustments.

FAILURE TO UNPLUG

THE SAW COULD RESULT IN ACCIDENTAL

STARTING CAUSING POSSIBLE SERIOUS

PERSONAL INJURY.

BEFORE STARTING THE SAW

1. Make sure saw is unplugged.

2. Remove the right cutting table and ll the

water reservoir to the top of the overow

opening (see FIGURE 10). Do not ll above

this level.

NOTE: ALWAYS keep enough water in the

reservoir when operating the saw. DO NOT let

the saw run dry.

3. Re-attach and close right cutting table.

IMPORTANT: ALWAYS completely drain the

water reservoir and clean thoroughly after

each use.

FIGURE 10

TO START THE SAW

1. Remove cord from compartment under the

saw and connect it to a GFCI (Ground Fault

Circuit Interrupter) protected outlet (see

FIGURE 11).

3.Push On/Off switch to the “On” position.

FIGURE 11

2. Create “drip loop” in the cord (see

FIGURE 12).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Comments to this Manuals

No comments