QEP 22500 Owner's Manual download pdf (Page 8)

– 6 –

COULD RESULT IN POSSIBLE SERIOUS

PERSONAL INJURY.

INSTALLING THE BLADE

(see FIGURE 4)

1. Carefully place the blade onto the shaft and

push it against the inner ange.

2. Be sure the side of the blade with the

directional arrow is facing towards you.

3. Place the outer ange and the blade shaft

nut onto blade.

4. Firmly tighten the blade shaft nut with the

included wrench, but do not over tighten.

USE ONLY

CONTINUOUS RIM BLADES WITH THIS SAW.

DO NOT USE SEGMENTED, “TURBO” BLADES,

WOOD SAWING BLADES, BLADES WITH

OPENINGS, OR ANY OTHER CUTTING DEVICES

WITH THIS TILE SAW. USING THESE BLADES

COULD RESULT IN SERIOUS PERSONAL

INJURY AND DAMAGE TO THE SAW.

FIGURE 4

INSTALLING THE BLADE GUARD

(see FIGURE 5)

1. Place the guard support into the socket.

2. Be sure the support is parallel to the blade.

3. Place blade guard onto the support and

tighten wing nut.

FIGURE 5

INSTALLING THE RIP GUIDE

(see FIGURE 6)

1. Place rip guide on the top of the cutting

table and clamp both ends.

NOTE: The rip guide can be placed on either

the left or right side.

FIGURE 6

INSTALLING THE ANGLE GUIDE

(see FIGURE 7)

1. The angle guide is designed to t on top

of the rip guide. Simply place notch in angle

guide onto the top of the rip guide.

NOTE: The angle guide can be placed on either

the left or right side.

FIGURE 7

OPERATION

IMPORTANT: ALWAYS turn off the saw and

remove the plug from the outlet BEFORE

adding or removing accessories and making

adjustments.

FAILURE TO UNPLUG

THE SAW COULD RESULT IN ACCIDENTAL

STARTING CAUSING POSSIBLE SERIOUS

PERSONAL INJURY.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Comments to this Manuals

No comments